Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
At low speed (dial setting: 1 or 2) do not cut a
wood with a thickness of more than 3/8" (10
mm) or metal with a thickness of more than
1/32" (1 mm).
9. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which
moves the blade back and forth, as well as up
and down. Set the change knob shown in Fig.
7 to "0" to eliminate the orbital operation (the
blade moves only up and down). The orbital
operation can be selected in 4 steps from "0"
to "III".
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft
material, such as lumber, plastic, etc., increase
the orbital operation to increase work
efficiency. To cut the material accurately,
decrease the orbital operation.
10. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by
using No. 97 blade. Carefully read "Concerning
cutting of stainless steel plates" for proper
operation.
11. Splinter guard (Sold separately)
Using the splinter guard when cutting wood
materials will reduce splintering of cut
surfaces.
Insert the splinter guard in the space on the
base, and push it completely. (see Fig. 8)
12. Chip cover (Sold separately)
Chip cover prevents chips from flying off and
improves the efficiency of dust collector (Sold
separately).
Insert the chip cover between the base and
lever, and push with a slight pressure until it
catches in place. (Fig. 9)
When removing chip cover, hold both sides of
knob and slightly open until it can be removed
from the Jig Saw.
NOTE: There is a possibility that chip cover is
frosted when cutting the metal.
Change knob
Fig. 7
Splinter
guard
Fig. 8
Lever
Chip cover
Fig. 9
English
Base
Base
9
Publicité
Table des Matières
