Metabo HPT CJ 110MV Instructions De Sécurité Et Mode D'emploi page 8

English
6. Changing blades
(1) Open the lever up to the stop. (Fig. 3-I)
(2) Remove fitted blade
(3) Insert new blade up to the stop in the balde
holder. (Fig. 3-II)
(4) Close the lever. (Fig. 3-III)
CAUTION:
Be sure to switch power OFF and disconnect
the plug from the receptacle when changing
blades.
Do not open the lever when plunger is moving.
NOTE:
Confirm the protrusions of blade inserted to
the blade holder surely. (Fig. 4)
Confirm the blade located between the groove
of roller. (Fig. 5)
7. Switch operation
<CJ110MV>
Pull the switch trigger to turn on the power,
and release it to turn it off.
To enable continual operations without your
finger pressing down on the trigger, pull the
switch trigger to its fullest extent and then
press the stopper.
Pull the switch trigger once again to release
the stopper. The power will then be turned off
when your finger is released from the switch
trigger.
<CJ110MVA>
Slide the slide switch forward to turn on the
power, and slide it backward to turn it off.
Once the slide switch has been moved forward,
it will not return to its original position
automatically when released.
8. Adjusting the blade operating speed
The jig saw is equipped with the electric control
circuit which enables stepless speed control.
To adjust the speed, turn the dial shown in Fig.
6. When the dial is set to "1", the jig saw
operates at the minimum speed (850 /min.).
When the dial set to "5", the jig saw operates
at the maximum speed (3,000/min.). Adjust the
speed according to the material to be cut and
working efficiency.
8
Fig. 3
Blade holder
Fig. 4
Blade
Roller
Fig. 5
Dial
CJ110MV
Fig. 6
Blade
Blade holder
Lever
Blade
Blade
Roller
Dial
CJ110MVA