Concerning Cutting Of Stainless Steel Plates - Metabo HPT CJ 160V Instructions De Sécurité Et Mode D'emploi

(2) In other materials
When cutting a window hole in materials other
than lumber, initially bore a hole with a drill or
similar tool from which to start cutting.
6. Angular cutting
The base can be swiveled to both sides by up to
45° for angular cutting. (Fig. 16)
(1) Loosen the base bolt by allen wrench attached
on base and move the base fully forward.
(Fig. 12)
(2) Align the scale (from 0 degrees to 45 degrees by
15-degree increments) of the semi-circular part
of the base with the [ ] mark on the gear cover.
(Fig. 17)
(3) Tighten the M5 bolt again. (Fig. 12)
(4) Set the orbital position to "0".
NOTE: Angular cutting can not be done when
adopting chip cover or dust collector.

CONCERNING CUTTING OF STAINLESS STEEL PLATES

When used with the No. 97 blade, can cut stainless steel plates.
Note the following to adjus the unit.
CAUTION
In order to prevent blade dislodging, damage or excessive wear on the plunger,
please make sure to have surface of the base plate attached to the work piece while
sawing.
When cutting stainless steel plates, adjust the unit as described below:
1. Adjust the speed
Blade
No. 97
NOTE: Dial scale reading is for reference only. The higher the speed is, the quicker the material
is cut. But the service life of the blade will be reduced in this case. When the speed is too
low, cutting will take longer, although the service life will be prolonged. Make adjustments
as desired.
2. Set the orbital position to "0"
NOTE: When cutting use cutting fl uid (oil base cutting fl uid) to prolong the blade's service life.
Thickness of material
1/16" – 5/32" (1.5 mm – 2.5 mm)
45°
45°
Fig. 16
Scale
Fig. 17
Dial Scale
Middle groove position
between scales "2" and "3"
English
Base
mark
Semi-circular
part
13