Concerning Cutting Of Stainless Steel Plates; Selection Of Blades; Housing The Allen Wrench - Metabo HPT CJ36DA Instructions De Sécurité Et Mode D'emploi

English
CONCERNING CUTTING OF STAINLESS
STEEL PLATES
When used with the No. 97 blade (sold separately), can
cut stainless steel plates.
Note the following to adjus the unit.
When cutting stainless steel plates, adjust the unit as described below:
1. Adjust the speed
Blade
No. 97
NOTE
Dial scale reading is for reference only. The higher
the speed is, the quicker the material is cut. But the
service life of the blade will be reduced in this case.
When the speed is too low, cutting will take longer,
although the service life will be prolonged. Make
adjustments as desired.
2. Set the orbital position to "0"
NOTE
When cutting use cutting fl uid (oil base cutting fl uid)
to prolong the blade's service life.
Dial
Oiler
22
Thickness of material
1/16" – 5/32" (1.5 mm – 2.5 mm)
2 - 3
Change knob
Fig. 33
CAUTION
● In order to prevent blade dislodging, damage
or excessive wear on the plunger, please make
sure to have surface of the base plate attached
to the work piece while sawing.
● Do not operate power tools in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust.
Jig saw create sparks which may ignite the dust
or fumes.
Middle groove position
between scales "2" and "3"

SELECTION OF BLADES

○ Accessory blades
To ensure maximum operating effi ciency and
results, it is very important to select the appropriate
blade best suited to the type and thickness of the
material to be cut. The blade number is engraved in
the vicinity of the mounting portion of each blade.
Select appropriate blades by referring to Table 7
(page 28).

HOUSING THE ALLEN WRENCH

○ It is possible to house the axiliary allen wrench on the
base (see Fig. 34).
Dial Scale
Base
Allen wrench
Fig. 34