Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
(2) Align the scale (from 0 degrees to 45 degrees by
15-degree increments) of the semi-circular part of the
base with the [ ] mark on the gear cover. (Fig. 22)
(3) Tighten the M5 bolt again. (Fig. 16)
(4) Set the orbital position to "0".
NOTE
Angular cutting can not be done when adopting chip
cover or dust collector.
Base
Semi-
circular part
CONNECTING WITH CLEANER
By connecting with cleaner (sold separately) through dust
collector (sold separately) and adapter (sold separately),
most of dust can be collected.
(1) Remove the allen wrench from the base.
(2) Move the base fully forward. (Fig. 16, 17)
(3) Attach the chip cover.
(4) Connect the dust collector with adapter. (Fig. 23)
(5) Connect the adapter with the nose of cleaner. (Fig.
23)
(6) Insert dust collector into the rear hole of the base until
the hook catches in the notch. (Fig. 24)
(7) Press the hook to remove the dust collector.
NOTE
Wear the dust mask additionally, if available.
16
Fig. 21
-mark
Scale
Fig. 22
Chip
cover
Base
Dust
collector
Notch
Base
Rear
hole
CONCERNING CUTTING OF STAINLESS
STEEL PLATES
CAUTION
In order to prevent blade dislodging, damage or
excessive wear on the Plunger, please make sure to
have surface of the base plate attached to the work
piece while sawing.
When cutting stainless steel plates, adjust the unit as
described below:
1. Adjust the speed
Blade
Thickness of material Speed
1/16" – 5/32"
No. 97
(1.5 – 2.5 mm)
NOTE
The higher the speed is, the quicker the material is
cut. But the service life of the blade will be reduced in
this case. When the speed is too low, cutting will take
longer, although the service life will be prolonged.
Make adjustments as desired.
2. Set the orbital position to "0"
NOTE
○ When cutting use cutting fl uid (oil base cutting fl uid) to
prolong the blade's service life.
Nose Cleaner
Adapter
Fig. 23
Hook
Nose
Dust
collector Adapter
Fig. 24
Middle speed
Publicité
Table des Matières
