PRESIDENT BILL FCC Manuel D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NB filter is activated
HI-CUT filter is activated
ANL filter is activated
SCAN function is activated
Indicates the frequency or the current menu (COLOR,
KEY-BP, EMG-ST, MIC-TP or for Alert)
Indicates current channel
5) ROGER BEEP ~ KEY LOCK
ROGER BEEP
(short press)
The ROGER BEEP sounds when the PTT switch (11) of the
microphone is released in order to let your correspondent
speak. Historically as CB is a "simplex" communication
mode, it is not possible to speak and listen at the same
time (as it is the case with a telephone). "Once the con-
versation was over, "Roger" was said in order to indicate
"received" or "message understood". The word "Roger"
has been replaced by a significant beep. That is where
the words "Roger beep" comes from."
Press the ROGER (5) key to
BEEP function.
When the function is activated, "
display.
KEY LOCK
(long press)
Press and hold the
appears on the display.
Press and hold the
"
" disappears from then display.
Note: The PTT switch (11) remains enable while the unit is
locked.
activate/deactivate
the ROGER
" appears on the
lock
then unit. "
key (7) to
unlock
key (7) again to
then unit.
6) ANL/NB ~ HI-CUT
ANL/NB
(short press)
A short press on the ANL/NB key (6) allows you to
between the following settings: no filter / ANL activated
/ ANL and NB activated.
The icon of the active filter appears on the display.
HI-CUT
(long press)
A long press on the HI-CUT key (6)
the HI-CUT filter. When the filter is activated "HI-CUT"ap-
pears on the display.
HI-CUT: Cuts out the high frequency interferences and has
to be used in accordance with the reception conditions.
When active, the filter is displayed on display.
7) CB/WEATHER CHANNEL ~ ALERT
CB/WEATHER CHANNEL (WX)
CB functions are not allowed in
a not allowed key and KEY BEEP function is activated,
the radio sounds error tone.
Press the CB/WX key (7) to
WX
mode. When
on the display.
WX
"
The
mode allows to hear weather information. When
the mode is activated, use the s/t keys (3) on the unit
or the UP/DN keys on the microphone to
the 7 weather channels to find the active channel in your
local area (see WEATHER FRENQUENCY TABLE page 59).
The display shows the selected weather channel and if
the unit receives a signal, "
10
activates/deactivates
(short press)
WX
mode. If user presses
alternate
between
WX
mode is activated, "
move
" and " " icons blink.
alternate
CB
and
" appears
through

Publicité

Table des Matières
loading

Table des Matières