Thermotte™ insulating plates
The insulation plates (Thermotte - FIG 2) are classified
as "wear and tear" parts which will require to be
exchanged after some years. The wear time will depend
on the individual use of your product.
Nordpeis offers a one-year warranty on these parts.
After this, replacements can be purchased.
If new plates are needed, contact your dealer:
A. Smoke baffle
B. Backplate
C. Bottom plate front
D. Bottom plate right
E. Bottom plate left
F. Lateral plate right (steel plate for models with side
glass (X)
G. Lateral plate left (steel plate for models with side
glass (X)
Please note: Wood logs that are too long can cause
strain and crack the plates, due to the tension created
between the side plates.
Door and glass
Should there be any soot on the glass it may be
necessary to clean it.
Use dedicated glass cleaner,
as other detergents may damage the glass. (NB! Be
careful, even dedicated glass cleaner can damage the
varnish on the door
frame).
the glass is to use a damp cloth or kitchen roll paper
and apply some ash from the burn chamber. Rub
around the ash on the glass and finish off with a piece
of clean and damp kitchen roll paper. NB! Only clean
when the glass is cold.
Check regularly that the transition between the glass
and the door is completely tight. Periodically, it may be
necessary to change the gaskets on the door to ensure
that the burn chamber is air tight and working optimally.
These gaskets can be bought as a set, usually including
ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Recycling of the ceramic glass
Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass, must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. In case it would be mixed with ordinary
A good advice for cleaning
glass, it would damage the raw material and could, in
worst case end the recycling of glass. It is an important
contribution to the environment to ensure that ceramic
glass does not end up with the recycling of ordinary
glass.
Packaging recycle
The packaging accompanying the product should be
recycled according to national regulations.
7. Warranty
Use replacement parts recommended only by
the Manufacturer.
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions see
the enclosed warranty card or visit our website:
www.nordpeis.com
8. Advice on lighting a fire
The best way to light a fire is with the use of lightening
briquettes and dry kindling wood. Newspapers cause a
lot of ash and the ink is damaging for the environment.
Advertising flyers, magazines, milk cartons and similar
are not suitable for lighting a fire. Good air supply is
important at ignition. When the flue is hot the draught
increases and door can be closed.
Warning: In order to avoid injuries, please be
aware that the surfaface may become hot during
operation and that extra care need to be taken to
avoid skin burn.
Warning: NEVER use a lighting fuel such as
petrol, kerosene, alcohol or similar for lighting
a fire. This could cause injury to you as well as
damaging the product.
Use clean and dry wood with a maximum moisture
content of 20%. Humid wood requires a lot of air for
the combustion, as extra energy/heat is required for
drying the humid wood and the heat effect is therefore
minimal. This in addition creates soot in the chimney
with the risk of creosote and chimney fire.
In case of a chimney fire, close the door and air
supplies on the stove / insert and call the Fire
Brigade. After a chimney fire the chimney must in
all cases be inspected by an authorized chimney
sweeper before you use the appliance again.
GB
Warning!
Warning!
21