Operation; Assembly; Power Unit; Brushcutter Or Trimmer - Zipper Maschinen ZI-GPS70G Mode D'emploi

13

OPERATION

For operation all safety devices and the belt must be used!
13.1

Assembly

Take care at the assembly that at existing dovetailings these intrude on each
other.

13.1.1 Power unit

• Mount the rod to the control panel 11 according to FIG B on the drive unit 1 and
attach it with the Allen screws.
• Then push the handle 28 on the extension rod 2 (Fig. C) and secure it with the Allen
screws.

13.1.2 Brushcutter or trimmer

• Then on the brushcutter attachment, the protective cover to be mounted according
to Figure 8 D, and secure it with the Allen screws.
• Then the sheet has or trimmer receiving 29 mounted on the bar (Fig. D).
This process is described in detail in chapter work.

13.1.3 Twig saw

 Befestigen Sie anschließend die Astsägeeinheit 4 laut Fig. E auf die zugehörige
Stange und ziehen Sie die Inbusschrauben an

13.1.4 Hedge Trimmer

• Then attach the hedge trimmer 3 according to Figure G on the associated extension
rod and tighten the Allen screws.

13.1.5 Mounting the desired implement (Fig. F)

• Prior to this work, the motor must be stationary!
• First screw the thumb screw 12.
• Then press the safety cover 13 to the outside.
• Press the lever below 13 and remove the rod mounted to the tool.
• Add the new rod into the opening.
• Press the lever again and make sure that engages when you release the lever 13a of
the hook inside the hole.
• Press the cover 13 to the rod and turn the hand screw 12 again.
• Hook the end even the strap 10 in the associated hole (see Figure A).
Z.I.P.P.E.R MASCHINEN GmbH  www.Zipper-maschinen.at
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
N O T I C E
OPERATION
Seite 46