Zipper Maschinen ZI-GPS70G Mode D'emploi page 42

 Work attentively, safety conscious and always be fully aware safe STAND when
working!
 Caution on uneven work surfaces and work surfaces with gradient-never trim
excessively steep slopes!
 Avoid use in wet grass slippery!
 Regular breaks the security risk reduced by loss of control due to fatigue.
 Go over again the working position.
 Abnormal posture avoid.
 Never go running,
 Trim always perpendicular to the slope, never up and down
• Never cut:
o standing on a ladder
o on trees
• WARNING: Gasoline is highly flammable!
• Before refueling, switch off engine
• Smoking and open flames are prohibited during refueling.
• Do not refuel when the engine and carburetor are still very hot.
• Refuel only outdoors or in a well-ventilated area .
• Avoid contact with skin and clothes (fire hazard) .
• After refueling, fuel cap seal well and check for leaks.
• Start the process at least 3m away from place.
• Spilled fuel is wipe immediately.
• Gasoline is kept only in specially designated containers
• If gasoline spills, no start attempt may be made . Instead, the engine of the petrol
contaminated area must be removed. Any attempt to start up to avoid volatilization
of the resulting gasoline vapors
• Damaged fuel tank or other tank caps must be replaced
• After trimming stop cock fuel close (if available).
• Remove before cutting all foreign objects (eg stones, branches, wire, etc.)
• Solid objects stones, metal parts, or the like. can be thrown out - risk of
injury!
Before the start, after the failure or shock, to check:
 The device and make sure that it is in good condition.
 The cutting tools for wear and damage.
 The muffler.
Damaged parts must be replaced immediately!
 Allow the engine never run in enclosed or confined areas.
 The exhaust contains poisonous carbon monoxide. The exposure can cause
unconsciousness and death.
 If the fuel tank has to be emptied, must be done outdoors this. Store the drained
fuel in a specially designed container or dispose of carefully
Z.I.P.P.E.R MASCHINEN GmbH  www.Zipper-maschinen.at
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
• At idle, the blade should not rotate!
• The maximum shaft speed must not exceed the specified
speed. Check settings
SAFETY
Seite 42