Manufacturer's Warranty - Dx Tools; Ec Declaration Of Conformity (Original); Cip Approval Mark - Hilti DX 460 GR Mode D'emploi

11. Manufacturer's warranty – DX Tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts, or other
products of equivalent quality, may be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent

12. EC declaration of conformity (original)

Designation:
Type:
Year of design:
We declare, on our sole responsibility, that this product
complies with the following directives and standards:
2006/42/EC, 2011/65/EU.
Hilti Corporation, Feldkircherstrasse 100,
FL-9494 Schaan
Norbert Wohlwend
Head of Quality & Processes Management Head BU Measuring Systems
BU Direct Fastening
08/2012

13. CIP approval mark

The following applies to C.I.P. member states outside
the EU and EFTA judicial area:
The Hilti DX 460 has been system and type tested. As a
result, the tool bears the square approval mark showing
approval number S 812. Hilti thus guarantees compli-
ance with the approved type.
Printed: 12.08.2013 | Doc-Nr: PUB / 5069839 / 000 / 02
Powder-actuated tool
DX 460-GR
2001
Tassilo Deinzer
BU Measuring Systems
08/2012
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
Technical documentation filed at:
Hilti Entwicklungsgesellschaft mbH
Zulassung Elektrowerkzeuge
Hiltistrasse 6
86916 Kaufering
Deutschland
Unacceptable defects or deficiencies, etc. determined
during use of the tool must be reported to the person
responsible at the approval authority (PTB, Braun-
schweig)) and to the Office of the Permanent Interna-
tional Commission (C.I.P.) (Permanent Internationial
Commission, Avenue de la Renaissance 30, B-1000
Brussels, Belgium).
en
13