Marking And Identification - EMAK MZ2500R Manuel D'utilisation Et D'entretien

CONTENTS
- General information and standards .... 21
- Marking and identification ................... 21
- Terms of use and restrictions ............. 22
- Guarantee ........................................... 22
- Specifications ..................................... 23
- Warning signs ..................................... 23
- Description of controls and main parts 24
- Setting up the controls ........................ 25
- Starting up the motor .......................... 26
- Using the controls ............................... 27
- Tips for working with the power hoe .. 27
- Adjusting the belt ................................ 28
- Cutter safety guard ............................. 29
- PTO shaft ............................................ 29
- Maintenance: ...................................... 29
- Fitting the cutter .................................. 30
- Airborne noise ..................................... 30
- Handlebar vibration ............................. 30
Before using the machine, read
this manual carefully and keep
it at reach for future reference.
The Manufacturer holds the right
to make modifications, without
prior notice and without incurring
into any sanctions whatsoever,
provided that the main technical
and safety features are kept.
It is forbidden to reproduce or distribute this
manual without first having obtained written
authorisation of the Manufacturer.
The above symbol is to call your attention
when an important information is given
concerning the safeguard of persons.
Failure to observe this warning may lead
to bad injuries and deadly risks.
PREFACE
IMPORTANT
The "IMPORTANT" writing indicates that
special precautions must be taken so as to
not damage the machine.
INFORMATION AND
GENERAL RULES
SPARE PARTS
You are highly recommended to use only
GENUINE SPARE PARTS. Orders must be
made by observing the rules given in the
Spare Parts Catalogue.
ENGINE MAINTENANCE
The rules for using and servicing the engine
are given in the appropriate booklet, a copy
of which is provided with each engine.
NOTE
The terms RIGHT and LEFT used in this
manual to locate the various components,
always refer to the normal travel direction of
the machine, that is, to the machine seen by
the operator in the driverís position.
IDENTIFICATION DATA
Upon receiving the machine, check for the
identification label on the handlebar support,
with the CE mark and machine's serial
number on it.
IMPORTANT!
Whenever requesting technical service or
ordering spare parts, always give the se-
rial number of the machine in question.
21