Cleaning The Particle Sensor - SilverCrest SLR 30 A1 Mode D'emploi Et Consignes De Sécurité

Cleaning the particle sensor

RISK OF ELECTRICAL SHOCK!
► Before cleaning the particle sensor, always switch off the appliance and
remove the mains plug from the socket!
NOTE
► Clean the particle sensor once a month when using the appliance in
continuous operation. If you only use the appliance occasionally, clean
the particle sensor after two months at the latest.
To clean the particle sensor, proceed as follows:
1. Switch off the appliance and pull out the mains plug.
2. Open the particle sensor compartment cover
by placing your finger in the cover
cover
Fig. 1
3. The lens of the particle sensor is located on the left (see fig. 2). Clean it with a
dry cotton swab or a soft, dry cloth.
4. Replace the cover
Press the cover
the housing
■ 12 │ GB │ IE
q
towards you until it opens.
q
into the corresponding openings in the housing
q
into the openings until the cover
6
.
q
on the back of the appliance
q
opening (see fig. 1). Then pull the
Fig. 2
q
audibly clicks into
6
.
SLR 30 A1