Preparations; Removing/Attaching Brush Pads - SilverCrest SHI 1.5 A1 Mode D'emploi

Preparations

Removing/attaching brush pads

You will have to remove the brush pad
to clean the brush pad
1) To remove the brush pad
and retain it in this position.
2) At the same time, pull the brush pad
where the release
3) You can now completely remove the brush pad
4) To replace the brush pad
the recesses on the hand unit
5) After this, press the other side down so that the lock
The release
SHI 1.5 A1
.
press the release
is located.
again, press both catches
must then be in the
to insert batteries
upwards on the side
.
position.
GB │ IE │ NI
or
towards
.
into
engages.
│
7 ■