BaByliss PRO MIRA CURL MKII BAB2666E Mode D'emploi page 11

D
• Once the hair is in place, let go
of the hair section and close the
handle to allow the hair to be
automatically taken into the curl
chamber. (Diagram E).
NOTE: If you continue to hold the
hair section after closing the handle
then the MIRACURL MKII will stop
and beep to indicate that you must
release the tension on the hair. If
you have taken too much hair, or
hair is not neatly going through
the centre of the appliance, the
MIRACURL MKII will again stop and
beep to indicate a problem. This
safety feature ensures that there will
be no tangles.
• The hair is automatically drawn
into the ceramic curl chamber
where it is softly held and heated
from all directions to effortlessly
form the curl.
• The automatic beep indicator
will start as soon as the handles
are closed together. There will
be 5 individual beeps. Hold the
styler still with the handles closed
together until the end of the
individual beeps.
There will then be four quick beeps
in succession. This indicates that
you can remove the styler from
the hair.
• It is very important that you
release the handles fully, and then
gently pull the styler away from
the head to free the hair and reveal
the curl (Diagram F). NOTE: Always
release the handles first to let the
curl free; if you pull away before
you open the handles, the curl will
be straightened out.
E
• To allow the curl to set, do not
comb or brush the hair until it
cools.
• Repeat around the head until all
sections of hair have been curled.
11
F