VOX Amplification Lil' Looper Manuel D'utilisation page 19

Determining the recording length
If you're recording without specifying a tempo
When recording has started without specifying a
tempo (TAP button: does not light up), the following
operations will occur if the LOOP pedal is pressed and
the recording is stopped.
• If you're recording while playing back the Loop 1 phrase,
the timing when you stop recording will be automatically
adjusted to an exact multiple of the Loop 1 length.
• If you're recording without playing back the Loop 1
phrase, recording will stop immediately.
Creating phrases of a precise length (Loop Quantize)
If you use the TAP button to specify the tempo before
recording, the Loop Quantize function will be enabled.
The recording length will automatically synchronize
with the tempo and time signature.
When the Loop Quantize function is enabled and
recording has started (TAP button: blinks red), the
following operations will occur if the LOOP pedal is
pressed and the recording is stopped.
• If you press the LOOP pedal, the end timing is
automatically corrected, the accurate loop length will
be created and the recording will stop.
Start REC
Phrase length
In the following cases, a recording may be
completed at an unintended position:
1. Recorded (Loop Quantize function is enabled)
when the tempo is set.
2. Loop is deleted when the metronome is turned
off. Only the tempo setting will remain at this
time (TAP button will blink).
If a loop is re-recorded under these conditions, the
recording will stop at an unintentional position
because the Quantize function will be enabled.
When this occurs, hold down the TAP button for
2 seconds once the loop is deleted, and re-record
after turning the tempo setting off.
Creating phrases
End REC
19