Initiating Recording When You Start Playing (Auto Recording Start); Recording On Loop 2 - VOX Amplification Lil' Looper Manuel D'utilisation

VOX Lil' Looper Owner's manual
Initiating recording when you start playing
(Auto Recording Start)
The Auto Recording Start function makes recording
begin the moment you start playing.
1.
Press the AUTO REC button to make it light-up.
2.
While holding down the AUTO REC button,
turn the LOOP LEVEL/VALUE knob to set the
sensitivity where the recording will begin.
Turning the knob counterclockwise will increase
the sensitivity, and turning the knob clockwise will
decrease it.
If the sensitivity is increased, the recording will
start at a low input level.
The sensitivity setting is saved even if the power
is turned off.
3.
Press the pedal of the loop to be recorded.
The REC status LED will blink red.
The Auto Recording Start function will turn on,
and the Lil' Looper will be in record-standby mode.
4.
Play your instrument.
Recording will begin the moment you start playing.
During recording, the REC status LED will light-
up red.
20

Recording on Loop 2

Now let's record a phrase on Loop 2.
1.
As desired, you can also adjust the effect pa-
rameters.
) p. 15 "Recording on Loop 1"
2.
Press the LOOP1 pedal to playback Loop 1.
3.
At the desired moment, press the LOOP2 pedal to
start recording.
Hint: If you press the LOOP2 pedal while recording
Loop 1, Loop 1 will switch to playback and Loop 2
will start recording.
4.
When you've played as long as you want the
loop to be, press the LOOP2 pedal.
Recording will end, and the loop will switch to
loop playback.
Note: The operations when the tempo is set
and a recording is performed are different from
the operations when the tempo is not set and a
recording is performed.
) p. 18 "Using the metronome as a guide while you
record"