Rotex RKHBH008BB3V3 Manuel D'utilisation page 35

Programming space cooling, quiet mode, or booster heater
(1)
mode
5 sec
5 sec
(1) Only applicable for tank with built-in electrical booster heater (RKHW*).
RKHBH/X008BB
Indoor unit and options for air to water heat pump system
4PW62575-1 – 10.2010
Programming space cooling, quiet mode, or booster heater mode
is carried out as follows:
Press the < button.
1
The actual mode is blinking.
Use the pi and pj buttons to select the mode you want
2
to program (space cooling
m
The selected mode is blinking.
Press the < button to confirm the selected mode.
3
The first programmed action is displayed.
4 Use the pi and pj buttons to consult the programmed
actions.
This is called the readout mode. Empty program actions (e.g. 3
and 4) are not displayed.
5 Press the < button for 5 seconds to enter the programming
mode.
Use the < button to select the action number you would like to
6
program or to modify.
7 Use the pi and pj buttons to set the correct action time.
Use the ba button to select:
8
■ For space cooling:
5 sec
■ For quiet mode and booster heater mode
9 Repeat steps 6 to 8 to program the other actions of the selected
mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
10 Press the < button for 5 seconds to store the programmed
actions.
If the < button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 is deleted.
You automatically return to step 4. By pressing the pr button
several times, you return to previous steps in this procedure and
finally return to normal operation.
5 sec
INFORMATION
Returning to previous steps in the programming procedure
without saving modified settings is done by pressing the
pr button.
c , quiet mode
(1)
).
x: switch cooling and the controller off.
-
- 9: set the temperature by means of the bi and
bj buttons.
a: to select automatic temperature calculation.
-
button to enable or disable the x action.
INFORMATION
Programming the booster heater operation
valid if field setting [4-03]=1, 2, or 3.
(1)
s , or booster heating
(1)
: use the ba
(1)
time is only
Operation manual
11