Star Progetti Heliosa 44 Mode D'emploi page 13

9.MAINTENANCE AND REPLACEMENT OF BULB
(TO BE PERFORMED BY QUALIFIED STAFF OR SPECIALIZED TECHNICIAN)
• THE GUARANTEE DOES NOT COVER REPLACEMENT OR REPAIR OF BULB.
• REPLACEMENT OF BULB IS TO BE PERFORMED ONLY BY PROFESSIONALLY QUALIFIED PERSONNNEL OR BY A SERVICING CENTRE.
• REMOVE DUST FROM THE REFLECTOR AND BULB PERIODICALLY WITH BRUSH OR COMPRESSED AIR FOR CONSTANT HELIOSA® HI
DESIGN 44 HEAT EFFICIENCY.
• THE REPLACEMENT BULB MUST BE THE SAME AS THE BULB SUPPLIED WITH THE DEVICE.
• REPLACEMENT WITH OTHER BULBS MAY DAMAGE THE DEVICE AND CAUSE IT TO BE UNSAFE. CONTACT STAR PROGETTI OR THE
RETAIL OUTLET AUTHORIZED TO SELL THE REPLACEMENT BULB, SPECIFYING THE MODEL AND CODE OF THE PURCHASED HEATER.
• THE INJECTION POINT ON THE BULB (c) MUST ALWAYS FACE OUTWARD.
BEFORE PROCEEDING WITH BULB REPLACEMENT, OPERATORS MUST:
1. FULLY DISCONNECT THE DEVICE FROM POWER SUPPLY AND MAKE SURE THE BULB IS COLD
2. NOT TOUCH THE BULB WITH THEIR BARE HANDS.
REPLACEMENT OF BULB
1. HELIOSA HI DESIGN 44
3. REMOVE THE FRONT COMPONENT OF THE DEVICE. UNSCREW
THE SCREWS OF THE CLAMPS TO WHICH THE TWO BULB CORDS
ARE CONNECTED.
5. INSERT THE NEW BULB INTO THE SPRING CLIPS, THE SHORTENED
CORDS OF WHICH ARE TO BE INSERTED INTO THE CLAMPS.
REASSEMBLE THE DEVICE BY PERFORMING THE ABOVE TASKS IN
REVERSE ORDER.
1
3
5
12
2. UNSCREW THE 4 BACK SCREWS.
4. REMOVE THE BULB FROM THE SPRING CLIPS.
6. APPLY THE SPARE HEAT-ELASTIC CAPS TO REPLACE
THOSE WHICH HAVE BEEN REMOVED.
2
4
6