Manitowoc Cleveland SGL-30-T1 Manuel De L'opérateur page 9

!
HINGE ADJUSTMENT INSTRUCTIONS
LUBRICATION PROCEDURE
Lubricate the following parts every three months to insure smooth operation and
reduce wear.
TRUNNION HOUSING, WORM SCREW AND TILT GEAR
to May 2006)
These parts are accessed throught the top cover of the console.
Apply grease to gear teeth. Check for excessive play and adjust with adjusting screw
located on top of cross bar.
TRUNNIONS
(prior to May 2006)
These parts are accessed throught the top cover of the console.
Apply grease to gear teeth. Check for excessive play and adjust with adjusting screw
located on top of cross bar.
TRUNNION2
(after May 2006)
On the left hand side of the skillet there are two grease nipples on the top back
portion of the trunnion housing.
MAINTENANCE
WARNING:
Any maintenance or service involving disassembly of components
should be made by a qualified service technician. Ensure gas,
electrical and water supply (if applicable) to the unit are shut off.
1. Fully lift cover to
release spring tension.
2. Using a 7/16" deep
socket adjust left and
right bolts evenly.
3. When properly
adjusted, cover should
rest at 70°.
(prior