General Safety Instructions; Special Safety Instructions - Clatronic ES 2611 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

42034-05-ES 2611

• Before commissioning this device please read the instruction manual

carefully.

• Please keep these instructions, the guaranty certificate, the sales receipt and, if

possible, the carton with the inner packaging!

• The device is intended exclusively for private and not for commercial use!

• Always remove the plug from the socket whenever the device is not in use, when

attaching accessory parts, cleaning the device or whenever a disturbance

occurs. Switch off the device beforehand. Pull on the plug, not on the cable.

• In order to protect children from the dangers of electrical appliances, never leave

them unsupervised with the device. Consequently, when selecting the location

for your device, do so in such a way that children do not have access to the devi-

ce. Take care to ensure that the cable does not hang down.

• Test the device and the cable regularly for damage. If there is damage of any

kind, the device should not be used.

• Do not repair the device yourself, but rather consult an authorised expert.

• For safety reasons a broken or damaged mains lead may only be replaced by an

equivalent lead from the manufacturer, our customer service department or a

similary qualified person.

• Keep the device and the cable away from heat, direct sunlight, moisture, sharp

edges and suchlike.

• Never use the device unsupervised! Switch off the device whenever you are not

using it, even if this is only for a moment.

• Use only original accessories.

• Do not use the device outdoors*).

• Under no circumstances must the device be placed in water or other liquid, or

come into contact with such*). Do not use the device with wet or moist hands*).

• Should the device become moist or wet, remove the mains plug from the socket

immediately*). Do not reach into the water.

• Use the device only for the intended purpose.

*) Please note the following „Special safety instructions...".

•

The metallic parts become extremely hot. Touch only the handle.

•

Place the machine on a heat-resistant, smooth, flat and non-slip surface.

•

In order to avoid overheating, do not place the machine inside or under a cabi-

net. Make sure that enough space is left around the machine.

•

Watch out for the hot vapor when opening the boiler lid.

•

Never use the machine without water in it.

•

Always fill the boiler with cold water.

•

In order to make sure that no vapor pressure is left from the previous brewing

operation, place a recipient filled with cold water under the vapor jet. Lift the

recipient until the vapor nozzle is immersed in the water. Turn the control knob

to vapor release mode.

04.04.2003 9:06 Uhr