Starmix eSwift AS+ Série Notice D'utilisation page 17

Switch Switch
plate ② position
0
1
1
0
2
1
0
1
3
A
0
1
A
4
R
The socket is always live, irrespective of the switch position.
Appliances with a vibrating function:
Adjust the switch ②c to the V setting (vibration) to turn on
the vibrator.
Appliances with an electronic suction force control feature
a rotary knob ②d with which the suction force can be
adapted to the object that is being suction cleaned.
6 Suction cleaning
The suction force of appliances with a handle tube can be matched
to the object being suction cleaned with the secondary air slide.
6.1 Dry suction cleaning
Dry suction cleaning must only be performed with a dry filter,
appliance and accessories so that the dust cannot adhere and
become encrusted.
If the appliance is used to vacuum soot, cement, gypsum, flour
and similar dusts, it is advisable to use a Fleece filter bag, and an
additional FSP filter sack when larger quantities are involved.
The Fleece filter bag must always be used in conjunction with
a second filter.
Function
Vacuum cleaner is switched off
Vacuum cleaner is running
Vacuum cleaner is switched off
Plug socket current-conducting
Vacuum cleaner is running
Plug socket current-conducting
Vacuum cleaner is switched off
Plug socket current-conducting
Vacuum cleaner is running
Plug socket current-conducting
Automatic operation
Cleaner is switched on and off at
the socket with attached electrical
tool.t
Vacuum cleaner is switched off
Plug socket current-conducting
Vacuum cleaner is running
Plug socket current-conducting
Automatic operation
Cleaner is switched on and off at
the socket with attached electrical
tool.
Manual vibrators.
Hold push button down for 15 sec.
to clean the filter.
Original operatin instructions in German
6.2 Wet suction cleaning
Suction cleaning is performed without a Fleece filter bag and
without a filter sack. The folded filter is suitable for wet suction
cleaning. Use a dry filter for subsequent dry suction cleaning.
An FSS foam filter should be used for larger quantities of water. The
float valve interrupts suction when the container is full. Turn off the
motor and empty the container and, if necessary the folded filter.
- When taking up water, the supplementary air slide on the handle
should be opened slightly.
- Always lift the suction hose out of the liquid before switching off.
- Due to the high suction force and flow-promoting container
shape, some water may flow out of the hose when the appliance
is switched off.
- The float valve can respond prematurely when larger quantities
of fluid are sucked up. Turn off the appliance, remove the filter
and empty out the water.
- The filter can be dispensed with when liquid is primarily sucked
up.
- A second (exchangeable) filter should be used for frequent
changeover between dry and wet suction cleaning.
- When taking up strongly contaminated water, we recommend
the use of a washable foam filter instead of the folded filter
which has been fitted. If the foam filter is not part of the scope
of delivery, this filter can be ordered under the accessory article
no. 41 32 97..
6.3 Emptying the container.
Turn off ②a, disconnect the plug ④, and open the lock-in closure
⑬. Remove the top section ① and hose from the container w.
Empty the container or remove the Fleece filter bag ⑰ from the
suction opening.
7 Cleaning
From time to time the filter sack should be brushed or beaten.
Folded filters should be cleaned with a soft brush or, possibly, with
water. Dry the filter and container thoroughly so that dust cannot
adhere to moist parts. To prevent dirt accumulation and encrustati-
on, dry dust must be removed before changing over to wet suction
cleaning. Clean the container and accessories with water. Wipe the
top section ① with a moist cloth.
Check the function of the float valve, clean regularly and always
inspect for signs of damage. (Turn the top section around and see
that the float closes properly.)
GB - 17