dirna Bergstrom TRP Dynamics Instructions De Montage page 29

DYNAMIC
Position the bushing and nut covers.
6
6
Use bushing to pass the wastewater pipe
7
through the Ø19 borehole to the inside of the
cabin.
On the studs, screw on (4) M6 nuts with (4)
8
Ø6 flat washers, which should be level with
the upholstery.
SEE ATTACHED DIAGRAM
VERY IMPORTANT
!
In the case of slanting upholstery, the
evaporator unit must be vertical or sloping
from the lower section to the outside in
order to prevent the condensation water
from dripping onto the upholstery.
Upholstery
Evaporator
bracket
Wastewater
tray
Wastewater
pipe
6
7
Truck plating
EXTERIOR
M6 Self-locking
nut
Protection cap
M6 stud
Flat wide-flanged
washer
Rubber washer
29
Upholstery
INTERIOR
M6 Nut (leave at
Evaporator
the height of the
base
upholstery)
M6 Nut
M6 Nut
Flat wide-
Flat wide-
flanged
flanged washer
washer
EN
®
8