Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12.3.
CLEANING OF THE ASH DRAWER
All the appliances are equipped with a hearth grate and an ash
drawer for the collection of the ashes (Picture 8 pos. A).
It is suggested to empty periodically the ash drawer and to avoid it
fills completely in order not to overheat the grate. Moreover, we
recommend leaving always 3-4 cm of ash in the hearth.
ATTENTION: The ashes removed from the hearth have to be
stored in a container made of fire-resistant material equipped
with an air-tight cover. The container has to be placed on a
fire-resistant floor, far from flammable materials up to the
switching off and complete cooling.
12.4.
MAJOLICAS
LA
NORDICA has chosen majolica tiles, which are the result of high-quality artisan work and therefore the majolica
may present crackles, speckles, and shadings. These characteristics certify their precious origin.
Enamel and majolica, due to their different coefficient of dilatation, produce microcrackles, which show their authentic
feature. For the cleaning of the majolica we suggest you use a soft and dry cloth; if you use a detergent or liquid, the
latter might soak in and make the crackles more visible.
13.
SUMMER STOP
After cleaning the hearth, chimney and hood, totally eliminating the ash and other eventual residues, close all the
doors of
the hearth and the relevant registers and disconnect the appliance from the chimney.
We suggest performing the cleaning operation of the flue at least once per year; verifying in the meantime the actual
status of the rope seals which cannot ensure the good operation of the equipment if they are not in good condition
and are not making a good seal! In this case the seals must be replaced.
In presence of dampness in the room where the stove has been placed, we advise you to put absorbent salts into the
hearth.
If you want to keep for long the aesthetic look of the
stove it is important to protect its internal walls in row
cast iron with neutral Vaseline.
14. CONNECTING A CHIMNEY OR OPEN
FURNACE TO THE FLUE
The smoke channel is the section of tube that connects
the product to the flue, in the connection these simple
but very important principles must be followed:
• for no reason must the smoke channel be used with
a diameter lower than that of the neck of the outlet
with which the product is fitted;
• each metre of horizontal route of the smoke channel
causes a small leak of charge which should be
compensated for by raising the flue;
• the horizontal section must never be higher than 2
m (UNI 10683-2005);
• each bend of the smoke channel considerably
reduces the draught of the flue which must be
compensated for by raising it suitably;
• the UNI 10683-2005 Regulation –Italy requires that
the bends or variations of direction must in no case
be greater than 2 including the emission into the
flue.
Wanting to use the flue of a chimney or open furnace, it
will be necessary to close the hood hermetically below
the inlet point of the smoke channel pos. A Picture 9.
If the flue is too large (e.g. cm 30x40 or 40x50) it is
necessary to duct it with a stainless steel tube of at
least 200 mm of diameter, pos. B taking care to close
the space between the tube itself and the flue
immediately below the chimney cap pos. C.
For any
further information, please contact your Dealer!
22
PLASMA 80:26 – 80v:30
A
Picture 8
C - Plugging
B
A – Hermetic closure
Inspection
hatch
Picture 9
7193601 – EN
Publicité
Table des Matières
