Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PLASMA 80:26 – 80v:30
1A - PRIMARY AIR register (left lever)
Below the hearth door, on the front left side, there is the primary air register, in the style of lever (Picture 1 - 1A)
With this air register, it is adjusted the passage of primary air
into the low part of the stove and through particular channels
flows in the fuel direction. The primary air is necessary for the
combustion process during lighting. The ash drawer must be
regularly emptied, so that the ash does not obstruct the entry of
the primary air for the combustion.
In order to open the air flow, the bar must be completely pulled
out.
During wood combustion, the register of primary air must be
opened only for a while, because otherwise the wood burns too
fast and the stove may overheat.
2A - SECONDARY AIR register (right lever)
Below the hearth door, on the right front side there is the
secondary air register (Picture 1 - 2A).
The secondary air, passing through the two lateral jambs of the
front side, heats itself starting the double combustion and keeping at the same time the glass clean (with open
register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2A).
3.
RULES FOR INSTALLATION
The stove, assembled and ready for the installation, must be connected with a junction to the existing flue of the
house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections must be
tight.
It is obligatory to respect the National and European rules, local regulations concerning building matter and
also fireproof rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention to
windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for the
connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped with a wall
connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your structure (see Chapt. 16 - A) can support the weight of the stove (weight to
support more-equal to 200 kg USE resistant screws WITH METAL RAW PLUG ( B)).
In case of insufficient carrying capacity it is necessary to adopt appropriate measures.
La NORDICA S.p.A. responsibility is limited to the supply of the appliance. Your plant has to be carried out in
compliance with the state of the art, according to the provisions of these instructions and good professional
practice, by qualified personnel, acting for companies authorized to acquire the whole responsibility for the
whole plant.
If the stove is installed on a wall made of flammable material, it is necessary to replace that part of the wall with a
non-flammable material layer, for instance ceramic, stone, glass or steel etc. The replaced part of wall must be as
large as the stove is and, starting from the stove bottom side it must protrude 100 cm at least from the top side (see
Chapt. 16 - C).
LA NORDICA is not responsible in case of modification of the product and for the use of not original spare
parts. The hearths must not be modified.
THE HEARTHS MUST NOT BE MODIFIED.
4.
FIRE SAFETY MEASURES
While installing the appliance, it is necessary to respect the following safety measures (Picture 2):
a) In order to ensure sufficient thermal insulation, respect the minimum safety distance from objects or furnishing
components flammable and sensitive to heat (furniture, wood sheathings, fabrics. etc.) and from materials with
flammable structure (see Picture 2 - A). All the minimum safety distances are shown on the product data
plate and lower values must not be used.
b) In front of the hearth, in its radiation area there must not be any flammable object or construction material
sensitive to the heat at least within 100 cm; This distance can be reduced to 40 cm if you will install in front of the
element to protect a retro ventilated and heat resistant protection.
The stove must work exclusively with inserted ash drawer.
7193601 – EN
1A
2A
Picture 1
15
Publicité
Table des Matières
