Definition; Rated Heating Value And Refueling Times; Description And Overall Dimensions; Description - deville C07831 Notice D'emploi

You are advised to road carefully and in full the
information provided in order to get the best
performance - and the most satisfaction - out of your
DEVILLE stove.
Failure to comply with the assembly, installation and
operating instructions places all responsibility upon
the person(s) concerned.
THIS APPLIANCE MUST BE INSTALLED IN
COMPLIANCE WITH CURRENT D.T.U.
SPECIFICATIONS.
INSTALLATION BY A QUALIFIED TRADESMAN IS
RECOMMENDED.

1 - DEFINITION

The Insert-Stove complies with French Standard NF D
35-376, Classification C-G-B-sf-Em/In 9 kW.
This is a continuons combustion heating appliance,
equipped with a grate using wood only, a semi-closed
combustion chamber, and designed to be incorporated
into either a fireplace to be built or an existing fireplace.

2 - RATED HEATING VALUE AND REFUELING TIMES

•
Rated heating value in accordance with French
Standard NF D 35-376 during testing at normal
speed : 9 kW.
- Obtained at a draught pressure of l0 Pa, loaded with
9,5 kg of wood consisting or 3 non-split hardwood
logs.
- The above value is the average value obtained
during the 3-hour test.
- To maintain this value, reload on to a bed of embers
of about 400 g, or 3 cm thick, and open the air
adjusting slide to the "normal burning rate" position
(Fig. 5).
•
The stove will stay in for longer than l0 hours, at
reduced speed, if fully loaded and with the damper
completely closed (Fig. 5).

3 - DESCRIPTION AND OVERALL DIMENSIONS

3.1 - Description

The main components of your stove are indicated below
and can also be found on Fig. 1.
The combustion chamber is in 4mm steel, and the
bottom of the stove includes a cast iron plate.
A sheet metal casing protects both the air-cooling
system around the combustion chamber and the
fireplace walls from heat radiation, ensuring both safety
and high performance.
The door is in cast iron and includes seals which ensure
smoke-tightness and enable the stove to stayin for a very
long time.
The damper situated in the lower part of the door is used
to adjust the fuel burning rate.
A secondary air intake is included in the upper part of the
glass in order to keep it clean and also so that wood
burns more efficiently.
Net weight of the applicance
Stripped weight (less door,
deflector, grate, backplate)
3.2 - Overall dimensions (Fig 2)
4 - SURROUNDS AND ACCESSORIES

4.1 - Surrounds

Your Insert-stove can be installed within either an
existing fireplace or a new DEVILLE fireplace.

4.2 - Optional extras

On request, the stove may be supplied with the following
accessories :
•
Two hot air outlets, dia 125 mm, réf. C07006.EU01,
for supplying hot air to adjacent rooms (Fig. 3).
•
A blower, réf. C07205 or C07816 (Fig. 4) :
- This is a cinvection accelerator consisting of a box
and a 2 speed blower.
With option C07006.EU01, the blower can be used
to send the hot air to adjoining rooms in
different directions. Duct length is limited to 4
metres.
- Forced air flow : 120m
- For further details, see installation Instructions(§
7.1)
- In this case, and in this case only, remove the metal
shield protecting the floor by sliding it out through
the two slots in the lower part of the stove.
•
Barbecue kit C07127.

4.3 - Installation of optional extras

Blower (C07205 or C07816) and hot air outlet assembly
(C07006.EU01) :
•
These should be installed before the stove is
installed in the fireplace.
•
For installation, see the instrustio,s supplied with
these optional items.
10
C07856 C07873 C07831
86 kg 89 kg 100 kg
50 kg 50 kg 50 kg
3
/hour.
two