Removing And Fitting The Appliance Door - Siemens VB578D0S0 Notice D'utilisation

Remove the two middle panels, along with their
5.
holders.
The two middle panels are not fastened using
Note:
retaining pins; instead, they are held in place using
holders.
Remove the holders to separate the two middle
6.
panels from one another.
Clean the panels with glass cleaner and a soft cloth.
7.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting the door panels
Reinsert the two middle panels.
1.
Notes
– You will know that you have inserted the two
middle panels correctly when you can see the
"Low-E" symbol on both panels.
– Make sure that the panels are seated correctly.
All holders must lay flat against the outer panel.
Reinsert the inner panel.
2.
The panel must first be inserted into the
Note:
retaining bar. The two fastening pins must then
engage in the holders provided for them.
Remove the locking pins and close the oven door.
3.

Removing and fitting the appliance door

If the oven is very heavily soiled, the oven door can be
removed for easier cleaning. Normally, however, this is
not necessary.
Removing the appliance door
Open the oven door fully.
1.
Lock the two hinges on the left and right using the
2.
locking pin (a).
The locking pins must be fully inserted into the
Note:
holes in the hinges.
Take hold of the sides of the oven door with both
3.
hands and close the oven door by approx. 30° (b).
Lift the oven door slightly and pull it out.
4.
Do not close the oven door fully,otherwise the
Note:
hinges could become bent and the enamel could be
damaged.
Fitting the appliance door
Take hold of the sides of the oven door with both
1.
hands.
Slide the hinges into the slots in the oven (a).
2.
The notch at the bottom of the hinges must
Note:
engage into the frame of the oven (b).
Lower the door.
3.
Remove the locking pins.
4.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
Appliance door
en
43