Removing The Oven Door; Replacing The Oven Door; Replacing The Oven Light; Maintenance - Siemens HE2415U Guide D'utilisation Et D'entretien

Removing the Door
WARNING
• Make sure oven is cool and power to the
oven has been turned off before removing
the door. Failure to do so could result in
electrical shock or burns.
• The oven door is heavy and fragile. Use
both hands to remove the oven door. The
door front is glass. Handle carefully to
avoid breaking.
• Grasp only the sides of the oven door. Do
not grasp the handle as it may swing in
your hand and cause damage or injury.
• Failure to grasp the oven door firmly and
properly could result in personal injury or
product damage.
1. Be sure to read the above WARNING before
attempting to remove oven door.
2. Open the door completely.
3. Flip lever on hinge toward you. (see Figure A).
4. Close the door to approximately halfway open.
5. Holding the door firmly on both sides using both
hands, pull the door straight out of the hinge slots.
Hold firmly, the door is heavy (See Figure B).
6. Place the door in a convenient and stable location
for cleaning.

Replacing the Oven Door

1. Holding the door firmly in both hands, place hinges
in hinge slots.
2. Open door all the way to expose hinges and slots.
Push lever (one on each hinge) away from you
(back toward range)
3. After moving the hinge brackets back down into
position, be sure to close and open the door slowly
to assure that it is correctly and securely in place.
4. Door should be straight, not crooked.
Replacing an Oven Light
1. Read WARNING at right.
2. Turn off power at the main power supply (fuse or
breaker box).
3. Remove the lens by unscrewing it.
4. Remove the light bulb from its socket by
unscrewing it.
5. Replace the bulb with a new one. Use a 40Watt
approved appliance bulb. Avoid touching the bulb
with fingers, as oils from hands can damage the
bulb when it becomes hot.
6. Screw the lens back on.
7. Turn power back on at the main power supply
(fuse or breaker box).
• Your range has two oven lights.
• Each light assembly consists of a removable lens,
a light bulb as well as a light socket housing that
is fixed in place.

Maintenance

Figure A
Figure B
• Make sure the oven and lights are
cooland power to the oven has been
turned off before replacing the light
bulb(s). Failure to do so could result in
electrical shock or burns.
• The lens must be in place when using
the oven.
• The lens serves to protect the light
bulb from breaking.
• The lens is made of glass. Handle
carefully to avoid breaking. Broken
glass could cause an injury.
• Light socket is live when door is open.
WARNING