Detailed Performance Data - ALFRA TML 100 Mode D'emploi

Detailed performance data for the TML 100 lifting magnet
Values shown for load capacity of the TML 100 are based on material S235 JR for the maximum, vertical tractive
force with 0° deviation from the load axis and additionally under a 6° inclined load in accordance with EN13155, in
each case with a 3:1 safety factor. This manual does not contain any instructions for use on round material, as the
TML 100 is designed for flat material and round material or arched objects may not be lifted.
Table 2
Thickness of
material
mm
2
3
4
5
6
>6
Thickness of
material
Inches
0.08
0.12
0.16
0.20
0.25
>0.25
The maximum dimensions of the loads to be lifted depend to a large extent on the geometry and flexural stiffness
of the work pieces, since, in case of bending, an air gap forms under the magnetic surface and the load-bearing
capacity decreases significantly.During each lift, watch for any deformation of the work piece that might occur and,
if necessary, check for any air gap developing at the edges of the TiN-coated magnetic surface (e.g. with a sheet of
2
paper; 80g/m ).
Immediately stop the lift if there is any excessive deformation or an air gap.
Never exceed the dimensions and/or the load-bearing capacity of the material thickness given
intable 2.
Load capacity in kg
Clean, flat, ground
surface
Air gap <0.1 mm
0° 6°
30 27
50 45
80 72
95 85
100 90
100 90
Load capacity in lbs
Clean, flat, ground
surface
Air gap <0.004 inches
0° 6°
66 59
110 99
180 162
210 189
220 198
220 198
Rusty, slightly
scratched surface
Air gap = 0.25 mm
0° 6°
25 22,5
40 36
60 54
70 63
70 63
70 63
Rusty, slightly
scratched surface
Air gap = 0.01 inches
0° 6°
55 49
90 81
130 117
155 139
155 139
155 139
Irregular, rusty or
rough surface
Air gap = 0.5 mm
0° 6°
22 19
35 31
45 40
50 45
50 45
50 45
Irregular, rusty or
rough surface
Air gap = 0.02 inches
0° 6°
50 45
75 67
100 90
110 99
110 99
110 99
21