Start-Up - ALFRA TML 100 Mode D'emploi

Start-up

You receive a completely assembled lifting magnet and a detailed operating manual. Please check the condition of
the goods upon receipt for any damage incurred during transport, and make sure the delivery is complete. If you
have any problems, please contact the manufacturer immediately.
1. Follow the safety instructions. Clean the workpiece and the lower magnetic plate of the lifting magnet.
2. Position the lifting magnet at the centre of gravity of the load. The lifting magnet is pre-tensioned slightly in order
s
toavoid inadvertent
3. Align the lifting magnet according to the desired application.
4. Turn the activation lever by 60° into the ON position until it audibly latches into place (with a slight tilting).
5. Move the load hook to the required position and lift the load by about 10 mm to check its deformation and the
magnetic holding force.
6. Now move your load slowly and smoothly. Avoid swinging or jarring.
7. After the load has been set down completely and safely, you can deactivate the lifting magnet. To do this, push
the activation lever at its far end upwards (1.) and move it into the OFF position (2.).
The maximum dimensions of the loads to be lifted depend to a large extent on the geometry and flexural stiffness
of the work pieces. This is due to the fact that, in case of bending,an air gap (view page19) forms under the
magnetic surfaceresulting in a significant decrease ofthe load-bearing capacity.During each lift, watch for any
deformation of the work piece that might occur. If necessary, check for any air gap developing at the edges of the
TiN-coated magnetic surface (e.g. with a sheet of paper; 80g/m
Immediately stop the lift if there is any excessive deformation or an air gap.
Never exceed the dimensions and/or the load-bearing capacity of the material thickness given
in table 2 (page 21).
lipping and droppingof the magnet (e.g. when used in a vertical or other forced position).
2
).
16