Britax MULTI-TECH II Mode D'emploi page 24

Masquer les pouces Voir aussi pour MULTI-TECH II:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
2. Installation of your child seat (positioned backward) in a rear
vehicle seat
2a
2b
2d
2e
IMPORTANT
– The child seat MUST always be used with a lap belt and diagonal
belt (approved according to UN/ECE Directive No. 16 or relevant standards).
IMPORTANT
– Do not use any carrying points other than those described in
these operating instructions and those labelled in the child restraint equipment.
NEVER
install a child seat backwards on a vehicle seat that is equipped with an
airbag.
Place the child seat with the support leg in the shortest position backwards on the
vehicle seat, so that the rocking base is lying against the back of the vehicle seat.
After placement, the gap between the child seat and the car seat should not be
larger than 10 mm
(Fig.
2c
Open both buckles. Pull the lap and diagonal harness out sufficiently
600-900mm). Put the belt through the belt buckle guide on the opposite side
of the buckle and into the belt tunnel
in the seat cover in order to simplify the insertion of the belt through the belt
tunnel and under the seat cover
Push the belt through the belt tunnel, fasten it on the other side and put the
belt tongue into the buckle
Pull the loose seatbelt through the child seat in order to ensure that the
seatbelt is not twisted. When the belt is tight, close the buckle on the side
of the belt buckle and ensure that the lap belt and diagonal belt are secured
(Insert in Fig.
2d).
Close the belt buckle on the other side and ensure that only the lap belt is
secured
(Fig.
2d).
Ensure that both belt buckles have locked in.
If the belt buckle is no in the position that is market with a
the seat cannot be correctly fastened
car.
2a).
The child seat can touch the vehicle
seat in front, but must not press against
it. If the child seat touches the vehicle
seat in front, adjust it so that the driver
or passenger is not in an uncomfortable
position. If this is not successful, try a
different position in the car for the child
seat.
(Fig.
2b). There are two access slots
(Insert in Fig.
(Fig.
2c).
(Fig.
2e), try it on a different seat in the
(approx.
2b).
as incorrect and

Publicité

Table des Matières
loading

Table des Matières