Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PREPARING THE TOOL BEFORE DRIVING
After reading and understanding this entire manual, connect tool to air supply.
CAUTION: Keep tool pointed away from yourself and others at all times.
Always connect tool to air supply before loading fasteners. Do not load fasteners with
trigger or safety depressed. Always wear Z87 approved safety glasses, and hearing
protection when preparing or operating the tool. Never use a tool that leaks air or needs
repair.
Depress Handle (See A Fig. 14) and open the Latch. Rotate the Upper Nail Housing to the side of
the Body.
The Adjuster Plate can be moved up and down when twisting the Adjuster Nut (see B Fig.15) .
According to the length of nail, the Adjuster Plate should be adjusted correctly to the position
indicated inside Lower Nail Housing.
Place a coil of nails over the Lower Nail Housing. Uncoil enough nails to reach the Feed Hook and
place the second nail between the teeth on the Feed Hook. (see Fig. 16).
Close the Upper Nail Housing and depress the Latch (see Fig. 17).
Adjust directional EXHAUST deflector (see Fig. 18), so that the exhaust air blast will be directed
away from the operator. Grasp the deflector and rotate it to the desired position for the current
application.
6
Publicité
Table des Matières
