Power Source - Senco S65CNP Manuel D'utilisation

OPERATING INSTRUCTIONS
FOREWORD
S65CNP is a heavy duty, coil fed, pneumatic nailer using compressed air as a power source. It is
designed to install 32-65mm or 2,3-2,9mm diameter nails of various lengths. It is widely used for
connection of frame and connection of frame and felt. The tool has a magnesium alloy body and
the cylinder cap is of light and provides, high specific strength and rigidity.

POWER SOURCE

This tool is designed to operate on clean, dry, compressed air at regulated pressures 4.9 and 8.3
bar. The preferred system would include a filter, a pressure regulator, and automatic oiler located
as close to the tool as possible (within15 feet is ideal).
All compressed air contains moisture and other contaminates that are detrimental to internal
components of the tool. An air-line filter will remove most of these contaminates and significantly
prolong the life of the tool. If an in-line oiler is not available: place five or six drops of tool oil into
the tool's air inlet at the beginning of each workday.
Only disconnect the quick connector with the body tail portion of the air inlet. No compressed air
can be guaranteed when disconnecting. If operation is not correct, the tool can remain charged
with air after being disconnected and still be able to drive a fastener causing personal injury.
CAUTION: All line components (hoses, connectors, filters, regulators, etc.) must meet
150% of the maximum system pressure. Please try to use a hose of ID 9,5mm
connecting the nailer with compressor when disconnecting.
Do not connect this tool to a system with maximum potential. Only disconnect quick connector
being connected with the connector of the body tail portion air inlet, no compressed air can be
guaranteed another location, or handing the tool to another person.
Disconnect tool from air supply before performing maintenance, clearing a jammed fastener,
leaving work area, moving tool to other location,
5