Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Runs slowly or has power loss
Fasteners are jammed
9
3.Tool dry and lacks
lubrication.
4.The spring on the small
piston is damaged.
5.Air pressure is low.
6.Connecting screw of nose
and body is loose.
7.Stopped hook can't stop the
fasteners.
8.Bent fasteners.
9.Wrong size fasteners.
10.Small piston bumper is
worn and damaged.
11.Feed hook is binding.
12.Nail length is not correct
with loading space of nail
housing.
13.Weld wires in nail coil are
broken.
1. Tool dry, lacks lubrication
2. The spring in the cylinder
cap is damaged.
3.Having foreign matters
between piston assembly and
cylinder.
4.Have not assembled the
cylinder to home position.
5.O-ring on the valve is dry
after disassembly.
6.Air pressure is too low.
7.Driver is worn (sort)
8.Inner diameter of used hose
is small
1.Fasteners are wrong size.
2.Weld wires in nail coil are
broken.
3.Use pneumatic tool oil.
4.Replace small piston spring.
5.Increase the air pressure,
but don't exceed 8.3 bar.
6.Tighten all screws.
7.Replace taper spring of the
stopped hook.
8.Use recommended fasteners.
9.Use recommended fasteners
10.Replace bumper and
lubricate small piston.
11.Clean feed hook and torsion
spring.
12.Adjust adjuster plate at the
nail housing tail portion
according to the recommended
nail length to make arrow on
the nail housing tail point to
correct direction.
13.Stop using.
1.Use pneumatic tool oil.
2.Replace the spring in the
cylinder cap.
3.Disassemble/clean/lubricate.
4.Reassemble after
disassembling.
5.Reassemble after lubricating
6.Increase the air pressure,
but don't exceed 8.3 bar.
7.Replace piston assembly.
8.Use bigger inner diameter of
the hose.
1.Use recommended fasteners.
2.Stop using.
Publicité
Table des Matières
