Replacing Brushes - Panasonic QUICKDRAW MC-V7388 Manuel D'utilisation

Agitator Shaft
Eje del agitador
Arbre d'entraînement
Agitator Pulley
Polea para correa
Poulie de la courroie
Push Off
Empuje hacia
fuera
Pousser

Replacing Brushes

Card
Tarjeta
Carte
E-Clip
Sujetador
de E
Bride en E
Right End Cap
Tapa de extremo
derecho
Bouchon droit
Agitator Holder
Soporte del'agitador
Support de l'agitateur
Brush
Cepillo
Brosse
➢ ➢ When the bristles on the agitator are
so worn that they do not touch a card
held across the lower plate, the
brushes should be replaced.
➢ ➢ Remove lower plate and agitator.
➢ ➢ Remove the E-clip from agitator shaft
and end cap.
➢ ➢ Do not bend agitator shaft or lose E-
clip.
➢ ➢ Pull agitator shaft out of agitator
body.
➢ ➢ Pull, or pry out, agitator holder and
belt pulley.
➢ ➢ Push each brush out of agitator body
as shown.
➢ ➢ Install new brushes by reversing
procedure.
➢ ➢ Reinstall agitator holder and agitator
pulley completely.
➢ ➢ Reinstall the agitator shaft, end cap
and E-clip.
➢ ➢ See enlarged view for correct
assembly of parts.
➢ ➢ Position belt over belt pulley on the
agitator.
➢ ➢ Reinstall agitator and lower plate.
- 36 -