Replacing Brushes - Panasonic QUICKDRAW MC-V5269 Manuel D'utilisation

Agitator Shaft
Arbre d'entraînement
Eje del agitador
Agitator Pulley
Poulie de la courroie
Polea para correa
Push Off
Pousser vers l'extérieur
Empuje hacia fuera

Replacing Brushes

Card
Carte
Tarjeta
E-Clip
Bride en E
Sujetador
de E
Right End Cap
Bouchon droit
Tapa de extremo
derecho
Agitator Holder
Support de l'agitateur
Soporte del'agitador
Brush
Brosse
Cepillo
When the bristles on the agitator are
worn so that they do not touch a card
held across the lower plate, the
brushes should be replaced.
Remove lower plate and agitator.
Remove the E-clip from agitator shaft
and end cap.
Do not bend agitator shaft or lose E-
clip.
Pull agitator shaft out of agitator
body.
Pull, or pry out, agitator holder and
agitator pulley.
Push each brush out of agitator body
as shown.
Install new brushes by reversing
procedure.
Reinstall agitator holder and agitator
pulley completely.
Reinstall the agitator shaft, end cap
and E-clip.
See exploded view for correct
assembly of parts.
Position belt over agitator pulley on
the agitator.
Reinstall agitator and lower plate.
- 32 -