Table des Matières
Publicité
Installation
Installation
Input Panel
The input panel for all models are identical. They include a single screw-terminal barrier strip. Each terminal
accepts a wire gauge of 10 AWG to 18 AWG.
Tap switch: Rotate to adjust tap setting. Use a flathead screwdriver.
q
Barrier strip
w
Securing the Wiring
Feed the wiring through the gland nut on the bottom of the input panel. Once you are done wiring your
loudspeaker, rotate the gland nut clockwise to seal the wire. Tighten the gland nut by hand until the wire is
held firmly in place, then tighten the gland nut an additional quarter turn. Do not over-tighten.
Note: Gland nut is rated IP68.
CAUTION: If the gland nut is not properly fastened, water could get into the input panel and damage
the loudspeaker.
16 • English
q
70/
100V
5W
10W
10W
20W
20W
40W
COM
40W
80W
80W
NC
8
8
PRO.BOSE.COM
w
ArenaMatch Utility • Installation Guide
Publicité
Table des Matières
