Placing A Roll Of Filter Paper; Rinsing Programme; Fig. 6 Feeding Diagram Filter Paper; Fig. 7 Flushing Programme - BRAVILOR BONAMAT FreshOne Frshn−001 Mode D'emploi

Machine automatique a café frais moulu
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
5.1.4
Placing a roll of filter
paper
27
A
24.1
24.11
B

Fig. 6 Feeding diagram filter paper

D Open the door (3.) with the supplied key.
D Slide a roll of filter paper over the holder (27.)
in such a way that it can unwind at the left
side.
D Press the service key into the opening (22.)
and turn the key clockwise so that it is fixed.
D Press key (19.2) to bring the Brewer room
(24.1) in the upper position.
CAUTION!
− Clean the filter under the brewer room (24.1)
very carefully. Do not use a hard brush or
hard tools to clean the filter.
D Sweep with the brush (18.) the coffee from the
filter, if necessary.
D Feed the filter paper under the guide (24.11).
D Feed the filter paper under the brewer room
(24.1).
D Feed the filter paper over the conveyor roll
(24.5) and under the conveyor wheels (24.4).
In order to feed the paper under the conveyor
wheels, press ratchet (A) and at the same time
support the brewer at point (B).
D Press key (19.2). The brewer room comes
down slowly again (resting position) and the
filter paper is pressed down to the brewer.
D Place a cup under the coffee outlet piece
(24.8).
D Tap a cup of coffee and check the paper
routing
D Remove the service key from the opening
(22.).
D Close the door with the key and place the
drip−tray in front of the machine again.
10
version
1.0
5.1.5
The machine has a rinsing programme to clean
the brewer. It is recommended to run this
programme daily.
D Open the door (3.) with the supplied key.
D Press the service key into the opening (22.)
and turn the key clockwise so that it is fixed.
D Place a jug under the coffee outlet piece
24.4
(24.8).
24.5
D Press key (19.3) at the inside of the door.

Fig. 7 Flushing programme

A flashing cup appears on the display to indicate
that the rinsing programme is active. The rinsing
programme flushes the brewer with hot water.
D Repeat the rinsing by pressing the key (19.3)
again until the water coming out of the coffee
outlet piece is clean.
D Remove the service key from the opening
(22.).
D Close the door with the key and place the
drip−tray in front of the machine again.
TIP
− The hot water system does not require daily
maintenance.

Rinsing programme

ECopyright Bravilor Bonamat B.V.

Publicité

Table des Matières
loading

Table des Matières