Installation; Use; Maintenance And Repairing Failures - BRAVILOR BONAMAT FreshOne Frshn−001 Mode D'emploi

Installation

D The maximum acceptable ambient temperature with which a good operation can be guaranteed is 40°C.
D Consider damage caused by freezing. Never place the machine in rooms in which the temperature
can drop below 0°C. After all, with normal use there will always be water in the machine.
D Do not turn over the machine, move it upright.
D Never install the machine in places where water is sprayed or sprinkled.
D Never install the machine in front of entrances, exits or passageways intended for emergency services.
D Place the machine on a sufficiently solid, flat surface close to a water connection, water discharge
and an earthed electrical power outlet.
D Connect the machine to the electrical supply in such a way that the power can easily be disconnected.
D Leave sufficient space at the back and front of the machine for maintenance and repair purposes.
D At the left of the machine leave a space of at least 5 cm. for ventilation.
D Connect the machine to a readily accessible, manually operated water tap, so that the water supply
can easily be turned off.
D Always observe local rules and standards when installing this machine.

Use

D Inspect the machine before use and check for damages.
D Protect the machine against water and moisture. Do not wet the machine by spraying and never
submerge the machine in water.
D Keep the operating controls free from dirt and grease.
D Note that during use some parts of the machine become very hot.
D Disconnect the electricity grid and the water supply when the machine will not be used for a longer
period. Clean the machine following the instructions in chapter 15. Make sure that there is no coffee
left in the ingredients container and empty the litterbin to avoid moulding. Discharge the water (chapter
17.).

Maintenance and repairing failures

D Repair and maintenance activities not included in this document must always be carried out by
service mechanics.
D If the mains lead is visibly damaged, it has to be replaced by a qualified service technician.
D Observe the given maintenance intervals. Overdue maintenance can lead to high repair costs and
may cause guarantee claims to become invalid.
D Do not carry out any maintenance activities concerning the machine before having it protected
against unintentional coming into operation. In such cases disconnect the electricity grid.
D Avoid contact with moving parts.
D Never leave the machine during maintenance activities.
D For cleaning the machine only use the cleansing agent and descaler recommended by the manufacturer.
D Always wear suitable facial protection and gloves while working with cleansing and descaling
materials. Wash your hands after using these materials.
D Prevent damage of the machine caused by spilled descaler solution. Remove spilled solution as
quickly as possible and follow the previously mentioned safety instructions.
ECopyright Bravilor Bonamat B.V.
VII
version 1.0