JB Systems Light LED DJ-BAR Mode D'emploi page 8

ENGLISH
 BY CA-8 EASY CONTROLLER:
Just connect this small controller to the 1/4" jack of the master unit, and you will be able to control the
following
FUNCTIONS:
BUTTON
STANDBY
Red  Orange 
1.Synchronous strobe in
white color Yellow  Green 
2.Synchronous strobe in Cyan  Blue 
rainbow colors Purple  Magenta 
3.Sound strobe in white White  Manual
FUNCTION
4.Sound strobe in color
rainbow colors
PS:
In this mode random
show (Sh 0) is active
Strobe select Color select
MODE
(LED OFF) (LED ON)
 BY UNIVERSAL DMX CONTROLLER:
You can use any standard DMX-controller. First choose the desired DMX-channel mode and give the unit
the correct DMX start address. (see earlier to learn how this should be done)
 BY LEDCON-02 CONTROLLER:
Make sure the LED DJ-BAR channel mode is set to "LEdC" (see earlier) and perform the automatic
address function on the LEDCON-02 before you start using the set! Further explanations and instructions
can be found in the user manual of the LEDCON-02.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
JB SYSTEMS 11/77
®
OPERATION MANUAL
ACTIONS
To blackout all LED panels
Show1  Show2 
1. Slow speed
...  Show12  Fade 2. Middle speed
3. Fast speed
Show select Speed setting
(LED slow blinking) (LED fast blinking)
LED DJ-BAR
ENGLISH
SPECIFICATIONS
Mains Input: AC 100V - 240V, 50Hz/60Hz
Power consumption: Max. 67 Watt
Fuse: T3,15A / 250V slow blow (20mm glass)
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
DMX channels used: 4/13/16 channels
Lamp: 848 LEDs (4x 212 LEDs)
Size: see drawing
Weight: 8 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS 12/77
®
OPERATION MANUAL
LED DJ-BAR