Storage; Safety - Johnson Pump SPX MDR Manuel D'utilisation

MDR
1.2.3
1.3
MDR/EN (1206) 3.2
Never lift the pump unit with only one fastening point. Incorrect lifts can cause personal injury and/
or damage to the product.

Storage

If the pump is not installed immediately, it must be stored in a dry and cool place.

Safety

Personnel who have a pacemaker should not be allowed to work with the magnetic
coupling! The magnetic field is sufficiently strong to affect the operation of a
pacemaker. A safe distance is 1 metre!
Important!
The pump must not be used for other purposes than recommended and quoted for
without consulting SPX distributor.
A pump must always be installed and used in accordance with existing national and local
sanitary and safety regulations and laws.
Always wear suitable safety clothing when handling the pump.
Anchor the pump properly before start up to avoid personal injury and/or
damage to the pump unit.
Install shut-off valves on both sides of the pump to be able to shut off the in-
and outlet before service and maintenance. Check to see that the pump can
be drained without injuring anyone and without damaging the environment
or nearby equipment.
Make sure that all movable parts are properly covered to avoid personal
injury.
Do not run the pump dry. If the pump is run dry there is a risk of pump breakdown caused
by generated friction heat. If there is a risk of dry running, install a suitable dry running
protection to avoid serious damages.
All electrical installation work must be carried out by authorized personnel in accordance
with EN60204-1. Install a lockable circuit breaker to avoid inadvertent starting. Protect
the motor and other electrical equipment from overloads with suitable equipment. The
electric motors must be supplied with ample cooling air.
If the pump is used for easily flammable liquids it is absolutely necessary
that the pump and the pipe system is filled up before start up and during
operation. Make sure that no air occurs in the system. Follow the
instructions for start up (see paragraph 3.3 "Start up").
Introduction 7