Water And Ice Dispenser - V-ZUG Polaris S Mode D'emploi

en

Water and ice dispenser

Fault
Despite prolonged operating time,
ice cubes are not being dispensed.
Ice cubes are in the ice cube
container but are not being
dispensed.
Ice cubes are jammed in the outlet
of the ice cube container
or in the ice crusher.
Ice cubes are watery.
Ice cubes have melted.
Water dispenser is not functioning. Tap turned off.
The ice maker does not make
enough ice or the ice is deformed.
Bubbling, gurgling noises in the
water line.
110
Possible cause
Tap turned off.
Water supply is interrupted. Water pressure
too low.
Ice and water dispenser is switched off. "IWD
off" is lit on the display panel.
Freezer compartment too warm.
Ice cubes are frozen together.
Freezer compartment door is open.
Power failure.
Water supply is interrupted. Water pressure
too low.
The appliance or ice maker has only just been
switched on.
A lot of ice has been taken.
Low water pressure.
The water filter is bunged up or used.
Temperature in the freezer compartment is too
warm.
Water supply is interrupted or water line is
blocked.
Remedial action
Turn on tap.
Inform plumber.
Switch on ice and water dispenser (see chapter "Special
functions", section "Switching off [IWD off]").
Lower temperature in the freezer compartment (see chapter
"Setting the temperature").
Remove and empty the ice cube container.
Remove the ice cube container and rotate the screw conveyor
by hand. Loosen any jammed chunks of ice with a wooden
chopstick.
Remove the ice cube maker, empty and rub dry.
Close the door.
Check whether the power is on.
Turn on tap.
Inform plumber.
Approx. 24 hours is needed until ice production starts.
Approx. 24 hours is needed until the ice cube container is filled
again.
Connect the appliance to the stipulated water pressure only
(see chapter Connecting the appliance, section Water
connection).
Change the water filter.
Set temperature slightly colder in the freezer compartment.
1. Check water supply.
2. Check whether the water line is blocked.
3. In certain cases, briefly switching off the ice and water
dispenser is sufficient (see [IWD off] in section 'Special
functions').