Water And Ice Dispenser - V-ZUG POLARIS S Notice De Montage Et D'utilisation

Fault
The refrigerating unit
is switching on more
frequently and for longer.
The temperature in
the refrigerator
compartment or freezer
compartment is too cold.
The frozen food is frozen
solid.

Water and ice dispenser

Fault
Despite prolonged
operating time, ice cubes
are not being dispensed.
Ice cubes are in the ice
cube container but are not
being dispensed.
Ice cubes are jammed
in the outlet of the ice cube
container or in the ice
crusher.
Ice cubes are watery.
Ice cubes have melted.
Water dispenser is not
functioning.
The ice maker does not
make enough ice or the ice
is deformed.
Possible cause
Appliance opened frequently.
The ventilation openings have been
covered.
Large quantities of fresh food
are being frozen.
Temperature has been set too low.
Possible cause
Tap turned off.
Water supply is interrupted. Water
pressure too low.
Ice maker is disconnected.
Ice and water dispenser is switched
off. "IWD off" is lit on the display
panel.
Freezer compartment too warm.
Ice cubes are frozen together.
Freezer compartment door is open.
Power failure.
Tap turned off.
Water supply is interrupted. Water
pressure too low.
The appliance or ice maker has only
just been switched on.
A lot of ice has been taken.
Low water pressure.
The water filter is bunged up
or used.
Temperature in the freezer
compartment is too warm.
Remedial action
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.
Increase the temperature (see Selecting
the temperature).
Loosen frozen food with a blunt object.
Do not use a knife or pointed object.
Remedial action
Turn on tap.
Inform plumber.
Switch on ice maker again (see chapter Ice and
water dispenser, section Disconnecting the ice
maker).
Switch on ice and water dispenser (see
"Switching on and off the ice and water
dispenser").
Lower temperature in the freezer compartment
(see chapter "Setting the temperature").
Remove and empty the ice cube container.
Remove the ice cube container and rotate
the screw conveyor by hand. Loosen any
jammed chunks of ice with a wooden chopstick.
Remove the ice cube maker, empty and rub dry.
Close the door.
Check whether the power is on.
Turn on tap.
Inform plumber.
Approx. 24 hours is needed until ice production
starts.
Approx. 24 hours is needed until the ice cube
container is filled again.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting
the appliance, section Water connection).
Change the water filter.
Set temperature slightly colder in the freezer
compartment.
en
51