Flash Compensation - Sony HVL-F43M Mode D'emploi

Flash compensation

When the flash unit is in a flash mode that supports TTL metering, the flash
intensity is automatically adjusted. However, you can correct this automatically
adjusted flash intensity.
• Flash modes that support TTL metering
– TTL mode
– WL CTRL mode when [TTL RATIO: ON] or [RATIO: OFF] is set
• Setting values:
-3.0, -2.5, -2.0~ ±0.0~ +2.0, +2.5, +3.0 (steps of 0.5)
-3.0, -2.7, -2.3, -2.0~±0.0~+2.0, +2.3, +2.7, +3.0 (steps of 0.3)
• You can change the power level interval (0.5 or 0.3) in the custom settings.
For the setting method, see "Changing the custom settings" (page 69) and "C09
To Change the power level interval" (page 72).
• Does not work with a camera that has an Auto-lock Accessory Shoe.
See online for compatible camera models. (Even with a non-compatible camera,
the flash compensation is shown when communication with the camera is off.
Even in this case, when communication with the camera is restarted the flash
compensation indicator disappears and flash compensation is not carried out.)
33
GB