Attaching A Cs-Mount Lens - Sony ExwaveHAD SNC-CS3N Manuel D'installation

Wiring diagram for sensor input
Mechanical switch/open collector
output device
Camera
Inside
5 V
2.35
kohms
1 pin
–
(Sensor In )
11 pin (GND)
GND
Wiring diagram for alarm output
Camera
Inside
4 or 6 pin
(Alarm output +)
Magnet relay
24 V AC/24 V DC,
1 A or less
3 or 5 pin
(Alarm output
22
GB

Attaching a CS-mount Lens

Outside
Mechanical
switch
or
Open collector
output device
Outside
5 V
Circuit
example
–
)
R
GND
Attaching a CS-
mount Lens
You can use a CS mount lens other than the
supplied lens with this camera.
Suitable lens
The lens must be a CS-mount type of less
than 1 kg (2 lb 4 oz). The protrusion behind
the mounting surface must be 4 mm (3/16
in.) or less.
CS-mount lens
4 mm (3/16 in.)
or less
About the auto-iris lens
You can use a DC-servo type auto iris lens
with this camera.
To connect the auto-iris lens, first replace
the plug on the lens cable with a plug that fits
the LENS connector (not supplied).
1
Detach the old plug from the lens
cable.
2
Solder the wires of the lens cable to
the pins of the plug.
For cable pin assignment, refer to the
instruction manual of the lens.
1
8
7
6
5
2
3
4