Vertical Water Heater On Base; Horizontal Wall-Mounted Water Heater - Underside Connection - Atlantic HM Notice D'utilisation Et D'installation

EN
Installation Manual: Fitting the water heater
Specifi c case:
Fitting a vertical wall-mounted water heater
on a tripod
The use of a compliant and compatible tripod is mandatory
when fi tting a water tank with a capacity greater than 100 L on
a non load-bearing wall (cannot support the weight of the full
tank).
First fi t the water heater on its tripod in order to mark
the mounting points.
Carry out the drilling.
Put the water heater back in place.
Must mount the upper bracket.
Fitting a vertical wall-mounted water heater Blinded 50L Slim
Fasten the wall plate to the wall
using M8 studs (pre-fi xed on the wall)
and M8 nuts
4.2.

Vertical water heater on base

Fitting a vertical water heater on a base (fi g. u)
does not require mounting.
Make sure you fi t it on a fl at surface.
You can use a riser (fi g. v)
to facilitate routing of the pipes.
4.3.

Horizontal wall-mounted water heater - Underside connection

A horizontal water heater can be fi tted to the wall, ceiling or fl oor. A horizontal water heater can be fi tted to the wall, ceiling or fl oor.
The cold water inlet and the hot water outlet must always be at the bottom.
È
Leave a free space of 400 mm underneath the cover in case the heater element in case the heater ele-
44
ment needs to be replaced.
u
È
v
È