Connecting The Cooler - Dometic CFX Série Notice D'utilisation

CFX100W
7.3

Connecting the cooler

Connecting to a battery
The cooler can be operated with 12 V
A
NOTICE! Danger of damage!
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
Using supplied DC connection cable
A
NOTICE! Danger of damage!
For protection of the device the DC cable supplied is fitted with a fuse.
Do not remove the fuse.
Only use the DC cable supplied.
➤ Before starting up the device for the first time, check whether the operating
voltage and the battery voltage correspond (see type plate).
➤ Plug the DC connection cable (fig. 1 2, page 3) into the DC voltage socket of
the cooler (fig. 4 5, page 4).
➤ Connect the red cable to the positive (+) battery terminal (fig. 8, page 6).
➤ Connect the black cable to the negative (–) battery terminal (fig. 8, page 6).
EN
g g
or 24 V .
Operation
19