Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
140G-G-F____, 140G-H-F____, 140G-I-F____, 140G-J-F____, 140G-K-F____
Installation instruction for Flex Cable Operator for 140G-G through K
Istruzioni di installazione
Installationsanleitung
Instructions pour l'installation
Instrucciones de instalación
Installation - Installazione - Instalación
Instalação -
WARNING:
To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA:
Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
WARNUNG:
Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden.
AVERTISSEMENT:
Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs.
ADVERTENCIA:
Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes.
ATENÇÃO:
Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes.
M4 x .7 x 12 mm
M4 x .7 x 12 mm
PN-353709
DIR 10000873178 (Version 07)
-
140G-G
140G-H
140G-I
140G-J
140G-K
Bul. 140G/140MG
#6-32 x .312 in
#10-32 x .22 in
Publicité
Manuels Connexes pour Allen-Bradley 140G-G-F Série
Sommaire des Matières pour Allen-Bradley 140G-G-F Série
- Page 1 Bul. 140G/140MG 140G-G-F____, 140G-H-F____, 140G-I-F____, 140G-J-F____, 140G-K-F____ Installation instruction for Flex Cable Operator for 140G-G through K Istruzioni di installazione Installationsanleitung Instructions pour l’installation Instrucciones de instalación Installation - Installazione - Instalación Instalação - WARNING: To prevent electrical shock, disconnect from power source before installing or servicing.
- Page 2 140G-K Shown Provided with Circuit Breakers U >0V > 1.0” (25 mm) Cable Length Diameter (Min.) 3 ft (0.9 m) 6.0”(152.4 mm) 4 ft (1.3 m) 12.0”(304.8 mm) 6 ft (1.9 m) 12.0”(304.8 mm) 10 ft (3.0 m) 12.0”(304.8 mm) PN-353709 DIR 10000873178 (Version 07)
- Page 3 140G-G 140G-H 1.378 in 0.984 in (35.0 mm) (25.0 mm) 140G-I 140G-J 4.213 in 4.803 in (107.0 mm) (122.0 mm) 1.378 in 1.181 in (35.0 mm) (30.0 mm) 10 - 15 lb-in 1.2 - 1.7 Nm 4.370 in 5.472 in (111.0 mm) (139.0 mm) 140G-K...
- Page 4 140G-K Shown T-20 10 - 15 lb-in 1.2 - 1.7 Nm 140G-M1, -P1 or -S1 PN-353709 DIR 10000873178 (Version 07)
- Page 5 140G-K Shown Enclosures with Right Hand Flange Enclosures with Left Hand Flange 7/16" (11 mm) 30 - 40 lb-in (3.5 - 4.5 Nm) 30 - 40 lb-in (3.5 - 4.5 Nm) 90° 7/16" (11 mm) 90° 140G-K Shown Enclosures with Right Hand Flange Enclosures with Left Hand Flange 7 - 11 lb-in 7 - 11 lb-in...
- Page 6 1 - Trip Breaker CLACK 2 - Reset Breaker See figure A Vedi figura A Siehe Abb. A Voir figure A Véase figura A CLACK 3 - Breaker On See figure B Vedi figura B Siehe Abb. B Voir figure B Véase figura B CLACK 4 - Breaker Off...
- Page 7 3/4" 3/4" (19 mm) (19 mm) When the breaker is switched extensively for long periods of time, periodically check and adjust the screw if necessary. Quando l'interruttore automatico viene commutato frequentemente e per lunghi periodi, controllare e regolare periodicamente la vite se necessario. Bei intensiver Nutzung des Leistungsschalters über einen längeren Zeitraum hinweg, überprüfen Sie bitte regelmäßig den festen Sitz der Schraube und ziehen Sie sie gegebenenfalls nach.
- Page 8 Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page. Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc. Trademarks not belonging to Rockwell Automation are property of their respective companies. PN-353709 Publication 140G-IN128H-MU-P - April 2020 DIR 10000873178 (Version 07) Copyright ©...