Table des Matières
Publicité
BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING • The Quick
• Do not use the equipment for other purposes.
• Quick
shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of the
®
equipment. • The windlass is not designed for the loads that might occur in extreme weather conditions (storms).
• Always deactivate the windlass when not in use.
• Check that there are no swimmers nearby before dropping anchor.
• For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally dam-
aged. • We recommend the use of the Quick
• The reversing contactor unit must be installed in a point protected from accidental water contact.
• After completing the anchorage, secure the rope to fixed points such as chain stopper or bollard.
• To prevent accidental releases, the anchor must be secured. The windlass shall not be used as the only securing device.
• Isolate the windlass from the power system during navigation (switch the circuit breaker off) and lock the rope securing
it to a fixed point of the boat.
THE PACKAGE CONTAINS: windlass PTR or PTG - reversing contactor unit (only mod. 700/1000) - 30 m (98 ft) chain
Dyneema (only PTR) - drill template - bolts and screws (for assembly) - user's manual - conditions of warranty.
TOOLS REQUIRED FOR INSTALLATION: drill bits: Ø 9 mm (23/64"), Ø 15 mm (63/64"); hexagonal wrenche: 13 mm.
"QUICK
"ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800 - WCS 810) - Waterproof hand helds
®
R/C (mod. HRC1002) - Foot switch (mod. 900) - Strap-roller with spring catch (only PTG) - Hydraulic-magnetic circuit brea-
ker - Radio control RRC (mod. R02, P02, H02).
PTG INSTALLATION REQUIREMENTS
The windlass must be positioned by aligning the flat strap (therefore the windlass' centre) with the hook of the tender to
be lifted. Verify that the upper and lower surfaces of the deck are as parallel as possible; in case they are not, compensate
the difference appropriately (the lack of parallelism could result in an unsafe installation). The deck thickness must be
included among the figures listed in the table. In case of other thicknesses please consult a Quick
PTR INSTALLATION REQUIREMENTS
The windlass must be positioned by aligning the reel with the bow roller. If the bow roller has already been installed,
ensure that it leans out of the bow (or the stern) so that the descent and ascent of the anchor on the bow roller meets
no obstacles. Verify that the upper and lower surfaces of the deck are as parallel as possible; in case they are not,
compensate the difference appropriately (the lack of parallelism could result in an unsafe installation). The deck thickness
must be included among the figures listed in the table. In case of other thicknesses please consult a Quick
INSTALLATION
FITTING PROCEDURE
when the ideal position has been established (On-Deck or to the wall) drill holes using the drilling template provided.
Remove excess material from the chain passage, refine and flatten with a specialized product (marine paint, gel coat or
two pack epoxy). Position the windlass paying attention to the passage of power and control cables. Screw the studs onto
the windlass. Connect the supply cables from the windlass to the reversing contactor unit (o to the battery in case the
inversing solenoid unit is integrated).
WARNING: before wiring up, be sure the electrical cables are not live.
PONTOON 350 - 700 - 1000 - REV002A
" DEALER.
®
windlasses are designed to weigh the anchor.
®
hydraulic-magnetic switch as the motor safety switch.
®
On-Deck
WARNINGS / INSTALLATION
®
Wall mount
EN
dealer.
dealer.
®v
15
Publicité
Table des Matières
