Making The Basic Settings - AL-KO Robolinho 500 Mode D'emploi

GB
4.6 Connecting the base station to the
power source (04)
1. Place the power supply (04/4) in a dry loca-
tion that is protected against direct sunlight
and sufficiently close to the base station
(04/1).
2. Connect the low voltage cable of the power
supply (04/5) and the cable of the base sta-
tion (04/6) with each other.
3. Plug the power plug of the power supply
(04/2) into a power socket (04/3).
NOTE
We recommend connecting the power
supply to the mains supply via an earth
leakage circuit breaker (ELCB) with a
rated leakage current < 30 mA.
4.7 Checking the connections on the base
station (04)
1. Check that both LEDs on the front side of the
charging station (09/1) light. If not:
■
Disconnect the mains plug.
■
Check that all plug connectors of the
power source and the boundary cable
are positioned correctly and check for
damage.
Status indications of the LEDs
LEDs Operating states
■
Green Lights up when the boundary
cable is laid correctly and the
loop is intact.
■
Flashes if a loop of the bound-
ary cable is not in order.
■
Yellow Lights up if the power source is
intact.
5 START-UP
This chapter describes the activities and settings
that are necessary to put the appliance into oper-
ation for the first time. For all further settings, re-
fer to see chapter 7 "Settings", page 50.
5.1 Charging the rechargeable battery (08)
The integrated battery is partially charged on de-
livery. During normal operation, the battery of the
appliance is regularly charged automatically.
48
NOTE
Fully charge the rechargeable battery
before using it for the first time. The re-
chargeable battery can be charged in
any charge status. Interrupting charging
does not damage the rechargeable bat-
tery.
The rechargeable battery can only be
charged after the appliance has been
switched on.
1. Place the appliance (08/1) in the base station
(08/3) so the contact surfaces of the appli-
ance touch the charging contacts of the base
station.
2. Switch on the appliance with
3. The display on the appliance shows Bat-
tery is being recharged. If not: see
chapter 14 "Help in case of malfunction",
page 56.
5.2

Making the basic settings

1. Open the cover flap.
2. Switch on the appliance with
ware, code number and type are displayed.
3. In the menu for language selection, use
or to select the language and accept with
.
4. In the Login > Enter PIN menu, enter the
preset PIN 0000. To do so, select the digit 0
in sequence with
confirm with
cess is enabled.
5. In the Change PIN menu:
■
Under Enter new PIN, enter a self-se-
lected new four-digit PIN. To do so, se-
lect one digit in sequence with
and respectively confirm with
■
Under Reenter new PIN, enter the
new PIN again. If both entries are identi-
cal, PIN changed is displayed.
6. In the Enter date menu, set the current
date (format: DD.MM.20YY). To do so, select
one digit in sequence with
spectively confirm with
.
. The firm-
or and respectively
. After entering the PIN, ac-
or and re-
.
Robolinho 500 E/I
Start-up
or
.