Edge Mowing With A Manual Start; Setting The Secondary Area Mowing; Setting The Display Contrast; Setting Lock - AL-KO Robolinho 500 Mode D'emploi

Displaying information

■
Change
or
lected setting.
■
Continue
or
changes setting and continue to the next
setting.
Save
3. or
tings of the menu item.
7.4 inTOUCH
An existing connection to a gateway can be dis-
connected. This means the appliance is ready to
establish a new connection for 30 minutes.
NOTE
To establish a connection later, the con-
nection must first be disconnected
again, even if the appliance was not pre-
viously connected with a gateway.
*inTOUCH
1. or
2. Reset connection
Appliance reports: Done.
3. Confirm with
7.5

Edge mowing with a manual start

For a manual start, the setting can be made here
that the appliance begins with edge mowing.
Carrying out the edge mowing at the pro-
grammed mowing time periods: see chapter 7.3.2
"Setting the mowing times", page 50.
* Margin mowing
1. or
* at manual start
2. or
7.6

Setting the secondary area mowing

* Sub zone mowing
1. or
2. Setting the mowing time periods:
■
inactive
or
Secondary area mowing is switched off.
■
active
or
The appliance mows until the recharge-
able battery is flat.
■
Mowing time in min
or
The appliance mows the secondary area
for the set time period. The following
mowing time periods can be set:
30/60/90/120/until rechargeable battery
flat.
457376_b
: Change the se-
: Confirm the
: Save all changed set-
and return to the menu.
:
:
7.7

Setting the display contrast

If the display is difficult to read, e.g. in sunlight,
the display can be improved by changing the dis-
play contrast.
* Display contrast
1. or
2. Increase/decrease the display contrast with
or and accept with
7.8

Setting lock

If the setting lock is deactivated, the PIN must on-
ly be entered when acknowledging safety-rele-
vant faults.
* Safety settings
1. or
2. Activating/deactivating the setting lock:
■
or
Activate the setting lock.
■
or
Deactivate the setting lock.
7.9 Recalibrating
If the position or length of the boundary cable has
been changed or the appliance no longer finds
the boundary cable, recalibration is necessary.
Reset calibration
1. or
2. Reset loop calibration data?
3. Carrying out a calibration movement: see
chapter 5.4 "Carrying out an automatic cali-
bration movement", page 49.

7.10 Restoring factory settings

The factory settings of the appliance can be re-
stored, e.g. before selling the appliance.
* Factory reset
1. or
Appliance reports: Factory reset com-
pleted
8 DISPLAYING INFORMATION
The Information menu is used for displaying
machine data. No settings can be made in this
menu.
1. Call up the main menu with
:
* Information
2. or
.
Activate
:
Deactivate
:
.
51